Avnet公司的ISM網絡FMC模塊能和任何的Avnet 或Xilinx有FMC功能的基板一起工作,采用FMC低引腳連接器連接到載板.具有兩個IEEE1588兼容的10/100以太網接口,兩個CAN接口,RS485 接口和RS-232接口,主要用于工業,科學和測量系統.本文介紹了ISM網絡FMC模塊主要特性,方框圖,以太網方框圖以ISM網絡FMC模塊電路圖和材料清單. The industrial networking FMC module adds key interfaces to support a wide range of industrial, scientific and measurement requirements. From dual 1588 compatible 10/100 Ethernet PHYs, to CAN, RS232, and RS485, the ISM Networking FMC can quickly get you started with either Spartan-6 or Virtex-6 based designs. The ISM Networking FMC Module is designed to operate with any Avnet or Xilinx base board that is FMC enabled. The module uses an FMC Low Pin Count (LPC) connector to interface to the carrier board. The industrial networking FMC module adds key interfaces to support a wide range of industrial, scientific and measurement requirements. ISM網絡FMC模塊主要特性: Board I/O Connectors — FMC LPC connector — (2) 8-pin GPIO headers (one per PHY) — 9-pin female DB9 for RS-232 communications — RJ-45 connectors for Ethernet communications Miscellaneous I/O Connectors — 4-position user selectable DIP switch — 6-pin Digilent header — 6-pin PHY JTAG header Memory — EEPROM #1: used as module identification for FMC compliance — EEPROM #2: used for EtherCAT configuration storage Communication — Dual IEEE 1588 compatible 10/100 Ethernet interfaces — Dual CAN interfaces — RS485 interface — RS-232 圖1.ISM網絡FMC模塊外形圖 圖2.ISM網絡FMC模塊方框圖 圖3.以太網方框圖 圖4.ISM網絡FMC模塊電路圖(1) 圖5.ISM網絡FMC模塊電路圖(2) 圖6.ISM網絡FMC模塊電路圖(3) 圖7.ISM網絡FMC模塊電路圖(4) 圖8.ISM網絡FMC模塊電路圖(5) 圖9.ISM網絡FMC模塊電路圖(6) ISM網絡FMC模塊材料清單: 詳情請見: https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-ug-reva062910.pdf 和 https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-sch-reva052810.pdf 以及 https://www.em.avnet.com/Support%20And%20Downloads/ism_networking_fmc_module-bom-reva041910.pdf 來源:網絡 |