国产毛片a精品毛-国产毛片黄片-国产毛片久久国产-国产毛片久久精品-青娱乐极品在线-青娱乐精品

IDT 90E36三相電能表設計方案

發布時間:2012-4-23 21:16    發布者:1046235000
關鍵詞: 90E36 , IDT , 三相電能表
IDT公司的IDT90E32/36三相電能計量芯片,集成了7個單獨的2階sigma-delta ADC,可實現三相四線系統中的三個電壓通路(A,B和C相)和四個電流通路(A,B,C相和中線),和標準IEC62052-11, IEC62053-22 and IEC62053-23, ANSI C12.1與ANSI C12.20兼容,動態范圍6000:1時的有功功率精度±0.1%,無功功率精度±0.2%,片內的基準電壓溫度系數6 ppm/ ℃,主要用于0.5S 級或1級三相四線(Y0)和三相三線(Y或Δ)電表,數據采集終端,電源監視儀表等.本文介紹了90E36主要特性,方框圖以及三相四線電流互感器(CT)電表電路圖和材料清單, 三相四線Rogowski線圈電表電路圖和材料清單, 三相三線電表電路圖和材料清單.

The 90E36 is a poly-phase high performance wide-dynamic range metering IC. The 90E36 incorporates 7 independent 2nd order sigma-delta ADCs, which could be employed in three voltage channels (phase A, B and C) and four current channels (phase A, B, C and neutral line) in a typical three-phase four-wire system.

The 90E36 has an embedded DSP which executes calculation of active energy, reactive energy, apparent energy, fundamental and harmonic active energy over ADC signal and on-chip reference voltage.

The DSP also calculates measurement parameters such as voltage and current RMS value as well as mean active/reactive/apparent power.

A four-wire SPI interface is provided between the 90E36 and the external microcontroller. In addition, DMA mode can be used for 7-channel ADC raw data access, offering more flexibility in system application.

The 90E36 is suitable for poly-phase multi-function meters which could measure active/reactive/apparent energy and fundamental/harmonic energy either through four independent energy pulse outputs CF1/CF2/CF3/CF4 or through the corresponding registers.

With the on-chip THD and DFT engine, all phases’ THD and DFT results can be directly accessed through related registers, thus simplifying hardware design in Data Acquisition Terminals.

IDT’s proprietary ADC and auto-temperature compensation technology for reference voltage ensure the 90E36’s long-term stability over variations in grid and ambient environment conditions.

90E36主要特性:

Metering Features

• Metering features fully in compliance with the requirements of IEC62052-11, IEC62053-22 and IEC62053-23, ANSI C12.1 and ANSI C12.20; applicable in class 0.5S or class 1 poly-phase watt-hour meter or class 2 poly-phase var-hour meter.

• Accuracy of ±0.1% for active energy and ±0.2% for reactive energy over the dynamic range of 6000:1.

• Temperature coefficient is 6 ppm/ ℃ (typical) for on-chip reference voltage.

• Single-point calibration on each phase over the whole dynamic ange for active energy; no calibration needed for reactive/ apparent energy.

• ±1 ℃ (typical) temperature sensor accuracy.

• Electrical parameters measurement: less than ±0.5% fiducial error for Vrms, Irms, mean active/ reactive/ apparent power, frequency, power factor and phase angle.

• Active (forward/reverse), reactive (forward/reverse), apparent energy with independent energy registers. Active/ reactive/ apparent energy can be output by pulse or read through energy registers to adapt to different applications.

• Programmable startup and no-load power threshold, special designed of startup and no-load circuits to eliminate crosstalk among phases achieving better accuracy especially at low power conditions.

• Dedicated ADC and different gains for phase A/B/C and Neutral line current sampling circuits. Current sampled over current transformer (CT) or Rogowski coil (di/dt coil); phase A/B/C voltage sampled over resistor divider network or potential transformer (PT).

• Programmable power modes: Normal mode (N mode), Idle mode (I mode), Detection mode (D mode) and Partial Measurement mode (M mode).

• Fundamental (CF3, 0.2%) and harmonic (CF4, 1%) active energy with dedicated energy and power registers.

• Total Harmonic Distortion (THD) and Discrete Fourier Transform (DFT) functions for 2 ~ 32 order harmonic component. THD and DFT results available in SPI accessible registers. Both voltage and current of all phases processed within the same time period.

• Event detection: sag, phase loss, reverse voltage/ current phase sequence, reverse flow, calculated neutral line current INC overcurrent sampled neutral line current INS overcurrent and THD+N over-threshold.

Other Features

• 3.3V single power supply. Operating voltage range: 2.8V~3.6V. Metering accuracy guaranteed within 3.0V~3.6V.

• Four-wire SPI interface with Direct Memory Access (DMA) mode to stream out 7-channel ADC raw data.

• Parameter diagnosis function and programmable interrupt output of the IRQ interrupt signals and the WarnOut signal.

• Programmable voltage sag detection and zero-crossing output.

• CF1/CF2/CF3/CF4 output active/ reactive/ apparent energy pulses and fundamental/ harmonic energy pulses respectively.

• Crystal oscillator frequency: 16.384 MHz. On-chip two capacitors and no need of external capacitors.

• TQFP48 package.

• Operating temperature: -40 ℃ ~ +85 ℃ .

90E36應用:

• Poly-phase energy meters of class 0.5S and class 1 which are used in three-phase four-wire (3P4W, Y0) or three-phase threewire (3P3W, Y or Δ) systems.

• Data Acquisition Terminal.

• Power monitoring instruments which need to measure voltage, current, THD, DFT, mean power, etc.

圖1.90E36方框圖

本文檔介紹了采用IDT90E32/36 三相電能計量芯片設計三相電能表的應用。

90E32/36 可用于0.5S 級或1 級三相有功電能表和無功電能表的設計,并可支持三相四線(3P4W) 或三相三線(3P3W)的接線方式,90E36 還可用于諧波表的設計。

芯片采用3.3V 單一電源供電。在典型的3P4W 設計中,需要三個獨立的變壓器進行供電。交流電源經整流和穩壓后輸出3.3V 到芯片數字電源DVDD,芯片模擬電源AVDD 應直接與DVDD 連接。

芯片內部具有上電復位電路,外部RESET 引腳可以接一個10kΩ 電阻到DVDD 和一個0.1μF 電容到GND。芯片具有高穩定性的片上基準電源,Vref 引腳需要外接10μF 和0.1μF 兩個電容。

芯片采用16.384MHz 頻率做為系統工作頻率,芯片內建了晶體振蕩電路和10pF 的匹配電容,應用時只需要在OSCI 和 OSCO 引腳接一個16.384MHz 晶體。

90E32 芯片提供三路電壓(V1、V2、V3) 和三路電流(I1、I2、I3)的A/D采樣,90E36還額外多提供一路電流采樣(I4)。

電流采樣中的I1 和I3 可以通過設置進行互換,以適應不同的PCB 設計。

芯片提供了一個四線的SPI 接口(CS,SCLK,SDI,SDO)與外部MCU 連接,MCU 可通過SPI 接口對芯片進行配置和讀寫寄存器。90E36 還可支持Master 模式的SPI,即DMA 模式。

在DMA 模式下,芯片會以高達1800kbps 的速率將A/D 的原始采樣數據通過Master SPI 輸出給外部微處理器進行處理。芯片提供了四個電能脈沖輸出引腳:有功電能脈沖CF1、無功電能脈沖CF2( 也可配置成全波視在電能脈沖輸出)、基波有功電能脈沖CF3、諧波有功電能脈沖CF4,可用于芯片電能計量的校準,同時也可以將脈沖信號連接到MCU 進行電能累計。

芯片提供了三個過零信號輸出引腳ZX0、ZX1、ZX2,可設置不同的電壓或電流信號做為過零判斷。

芯片提供了IRQ0、IRQ1、WarnOut 輸出引腳,分別輸出不同等級的中斷和報警信號。

三相四線(3P4W) 應用:

圖2.90E36三相四線電流互感器(CT)電表電路圖
三相四線電流互感器(CT)電表材料清單:


圖3.90E36三相四線Rogowski線圈電表電路圖
三相四線Rogowski線圈電表材料清單:


圖4.90E36三相三線電表電路圖
三相三線電表材料清單(BOM):

詳情請見:
IDT_90E36_DST_20111209.pdf (999.36 KB)
IDT_90E3xAN644Chn_APN_20111216_Zh.pdf (784.49 KB)

來源:網絡
本文地址:http://m.qingdxww.cn/thread-90678-1-1.html     【打印本頁】

本站部分文章為轉載或網友發布,目的在于傳遞和分享信息,并不代表本網贊同其觀點和對其真實性負責;文章版權歸原作者及原出處所有,如涉及作品內容、版權和其它問題,我們將根據著作權人的要求,第一時間更正或刪除。
您需要登錄后才可以發表評論 登錄 | 立即注冊

廠商推薦

  • Microchip視頻專區
  • Chiptorials ——如何將CryptoAuthLib庫用于Microchip安全身份驗證IC
  • Chiptorials——如何使用ATECC608 TrustFLEX實現公鑰輪換
  • Chiptorials ——使用ATECC608 TrustFLEX實現基本非對稱身份驗證
  • 無線充電基礎知識及應用培訓教程
  • 貿澤電子(Mouser)專區

相關視頻

關于我們  -  服務條款  -  使用指南  -  站點地圖  -  友情鏈接  -  聯系我們
電子工程網 © 版權所有   京ICP備16069177號 | 京公網安備11010502021702
快速回復 返回頂部 返回列表
主站蜘蛛池模板: 男人天堂v | 91在线高清 | 国产在线麻豆自在拍91精品 | 欧美高清视频一区 | 国产69久久精品成人看 | 大香线蕉免费观看视频75 | 第四色播日韩第一页 | 亚洲青青青网伊人精品 | 少妇高潮太爽了在线视频 | 四虎国产在线观看 | 这里只有久久精品 | 国产在线观看91精品不卡 | 四虎播放 | 亚洲人体一区 | 制服师生一区二区三区在线 | 久久机热综合久久国产 | 欧美一级日韩一级亚洲一级va | 国产第7页| 日本一区二区成人教育 | 91免费国产精品 | 五月天啪啪 | 日韩网站在线观看 | 青草资源视频在线高清观看 | 91日韩视频 | 在线观看视频网站www色 | 国产成人永久免费视频 | 亚洲国产成人成上人色 | 九九热精品在线视频 | 99热这里只有精品在线播放 | 花季传媒v3.0.3 | 亚洲三级视频 | 91亚洲专区| 青青草伊人 | 精品牛牛影视久久精品 | 99久久精品费精品国产一区二区 | 天天夜日日日日碰日日摸 | 五月天堂网 | 欧美日韩一区二区在线观看 | 在线亚洲观看 | 国产人成精品 | 女人十八毛片免费特黄 |